Module 8 Non-Replicable Measurement Systems
Lesson M8-06
Text: Section 6, pages 23 – 25
Duration: 12 minutes
- Measurement System Assessment
- References and Downloads
- M02 MSA Definitions
- M03 Gage R&R Studies
- 1 Overview and Planning for a Gage R&R Study
- 2 Analysis – Average and Range Method
- 3 Setting up and Analyzing a Gage R&R in Minitab
- 4 Exercise – Analyzing a Gage R&R Study
- 5 Analysis – ANOVA Method
- 6 Analyzing a Gage R&R in Minitab (ANOVA Method)
- 7 Exercises – Analyzing Gage R&R Studies (ANOVA)
- 8 Analysis – ANOVA with Significant Interactions
- 9 Gage R&R with Other Factors (Expanded Gage R&R)
- M04 SPC for Measurement Systems
- M05 Linearity & Bias Assessment
- M06 Attribute Systems Assessment
- M07 Comparing Measurement Systems
- M08 Non-Replicable Measurement Systems
Dynamic Part/Sample Properties
The last lesson explores the scenario where part or sample properties change over time, preventing replicate measurements. The two approaches for this situation (steady state testing and modeling) are described. An example of modeling is presented
- Measurement System Assessment
- References and Downloads
- M02 MSA Definitions
- M03 Gage R&R Studies
- 1 Overview and Planning for a Gage R&R Study
- 2 Analysis – Average and Range Method
- 3 Setting up and Analyzing a Gage R&R in Minitab
- 4 Exercise – Analyzing a Gage R&R Study
- 5 Analysis – ANOVA Method
- 6 Analyzing a Gage R&R in Minitab (ANOVA Method)
- 7 Exercises – Analyzing Gage R&R Studies (ANOVA)
- 8 Analysis – ANOVA with Significant Interactions
- 9 Gage R&R with Other Factors (Expanded Gage R&R)
- M04 SPC for Measurement Systems
- M05 Linearity & Bias Assessment
- M06 Attribute Systems Assessment
- M07 Comparing Measurement Systems
- M08 Non-Replicable Measurement Systems
Leave a Reply