Module 8 Non-Replicable Measurement Systems
Lesson M8-04
Text: Section 6, pages 9 – 10
Duration: 8 minutes
- Measurement System Assessment
- References and Downloads
- M02 MSA Definitions
- M03 Gage R&R Studies
- 1 Overview and Planning for a Gage R&R Study
- 2 Analysis – Average and Range Method
- 3 Setting up and Analyzing a Gage R&R in Minitab
- 4 Exercise – Analyzing a Gage R&R Study
- 5 Analysis – ANOVA Method
- 6 Analyzing a Gage R&R in Minitab (ANOVA Method)
- 7 Exercises – Analyzing Gage R&R Studies (ANOVA)
- 8 Analysis – ANOVA with Significant Interactions
- 9 Gage R&R with Other Factors (Expanded Gage R&R)
- M04 SPC for Measurement Systems
- M05 Linearity & Bias Assessment
- M06 Attribute Systems Assessment
- M07 Comparing Measurement Systems
- M08 Non-Replicable Measurement Systems
Destructive Testing (Multiple Measurement Locations)
Lesson 4 introduces a method of analyzing data that comes from multiple locations on a part due to the measurement being destructive at the location being measured. Assuming homogenous locations is the easiest approach, but methods that allow for non-homogenous locations exist and are briefly described.
- Measurement System Assessment
- References and Downloads
- M02 MSA Definitions
- M03 Gage R&R Studies
- 1 Overview and Planning for a Gage R&R Study
- 2 Analysis – Average and Range Method
- 3 Setting up and Analyzing a Gage R&R in Minitab
- 4 Exercise – Analyzing a Gage R&R Study
- 5 Analysis – ANOVA Method
- 6 Analyzing a Gage R&R in Minitab (ANOVA Method)
- 7 Exercises – Analyzing Gage R&R Studies (ANOVA)
- 8 Analysis – ANOVA with Significant Interactions
- 9 Gage R&R with Other Factors (Expanded Gage R&R)
- M04 SPC for Measurement Systems
- M05 Linearity & Bias Assessment
- M06 Attribute Systems Assessment
- M07 Comparing Measurement Systems
- M08 Non-Replicable Measurement Systems
Leave a Reply