Module 3 Gage R&R Studies
Lesson M3-01
Text: Section 2, pages 1 – 4
Duration: 18 minutes
- Measurement System Assessment
- References and Downloads
- M02 MSA Definitions
- M03 Gage R&R Studies
- 1 Overview and Planning for a Gage R&R Study
- 2 Analysis – Average and Range Method
- 3 Setting up and Analyzing a Gage R&R in Minitab
- 4 Exercise – Analyzing a Gage R&R Study
- 5 Analysis – ANOVA Method
- 6 Analyzing a Gage R&R in Minitab (ANOVA Method)
- 7 Exercises – Analyzing Gage R&R Studies (ANOVA)
- 8 Analysis – ANOVA with Significant Interactions
- 9 Gage R&R with Other Factors (Expanded Gage R&R)
- M04 SPC for Measurement Systems
- M05 Linearity & Bias Assessment
- M06 Attribute Systems Assessment
- M07 Comparing Measurement Systems
- M08 Non-Replicable Measurement Systems
Overview and Planning for a Gage R&R Study
In this first lesson, we discuss planning for a Gage R&R study. Selecting a sample of parts to be measured is an important aspect of the study and this is discussed in some detail. We also discuss randomizing and blinding the study as ways to prevent bias in the results. Finally, we talk about typical sample sizes and who should participate in the study.
- Measurement System Assessment
- References and Downloads
- M02 MSA Definitions
- M03 Gage R&R Studies
- 1 Overview and Planning for a Gage R&R Study
- 2 Analysis – Average and Range Method
- 3 Setting up and Analyzing a Gage R&R in Minitab
- 4 Exercise – Analyzing a Gage R&R Study
- 5 Analysis – ANOVA Method
- 6 Analyzing a Gage R&R in Minitab (ANOVA Method)
- 7 Exercises – Analyzing Gage R&R Studies (ANOVA)
- 8 Analysis – ANOVA with Significant Interactions
- 9 Gage R&R with Other Factors (Expanded Gage R&R)
- M04 SPC for Measurement Systems
- M05 Linearity & Bias Assessment
- M06 Attribute Systems Assessment
- M07 Comparing Measurement Systems
- M08 Non-Replicable Measurement Systems
Leave a Reply